Just casually moving a full garbage trailer with a Bosch Drill • This Valet has made it possible to fit 4 trailers in a parking spot I could normally only fit 2 in with my truck •
28/02/2026
Today could be the last day of mowing this year, they are calling for a lil snow tomorrow, yes it’s to early • Anyways I ran this New 22” super composite deck mower this year. It’s the
28/02/2026
This works perfect for putting the end details on this architrave • 3-5 seconds and it’s cured using the spray accelerator • This Makita 8-1 2 40v XGT miter saw makes a great
26/02/2026
Ridgid just came out with a stud and joist drill. • It has KickBack ProTech which shuts it down if there is a bind up so your arms don’t get pretzeled. • 2 speed and the key for the chuck
26/02/2026
It’s that time of year again. I blow out my dryer vent in spring and fall with this blower. • We are in the habit of cleaning the lint trap after every load so we don’t see much in the
26/02/2026
One of my favorite lights on my 4Runner is the Ditch lights • We live in a pretty secluded area and there isn’t a ton of oncoming traffic so I do get to run them a lot of the time on the
25/02/2026
When I originally showed this I got a lot of questions of what hardware I used. • I put a picture of it at the end of the video, it’s a $19 Amazon hidden bookshelf hinge that the homeowner
25/02/2026
PART 1 of building out the back of this 4Runner • There is a lot of options out there but I decided to go my own route • First I’m building a base out of 3 4” birch and covering with carpet
25/02/2026
Ok this is an interesting one, this rental I own is old and has had some additions added to it, seems they built right on top of an old walkway. • To top it off they used a bunch of massive
23/02/2026
We were working with some siding this morning, I had some long cuts to make and Dave brought this Ryobi HP Brushless 3” cutoff saw out from his van. • We’ve cut everything from plastic to
23/02/2026
Part 2 of the back of the 4Runner setup • A lot were asking why I built the carpeted base • It was for the fridge slide, I got a CFX5 fridge and it’s just easier to get at with a
23/02/2026
You can see this Makita deep rebar tier really pulls the rebar together nice and tight • I’ve seen comments saying it doesn’t tie tight enough, this video is a good example of how tight it actually gets it Tools USA
Be the first to know and let us send you an email when Jerica Luna posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.
