Calum Cuevas

Calum Cuevas Welcome to my page sharing about plumber life Please kindly Like and Follow. Thanks.

Floor professional install said this can be covered with quarter round.We had Coretec LVP installed today, and there are...
10/26/2025

Floor professional install said this can be covered with quarter round.

We had Coretec LVP installed today, and there are gaps all around the banister that are quite ugly. Installer said we need to use quarter round, but this area between the railing and new floor is almost flat. What can be done to fill this very noticeable gap?

Need to Turn off Water to Water Heater, why 2 Levers?
10/26/2025

Need to Turn off Water to Water Heater, why 2 Levers?

A sharkbite fitting should not be utilized within a wall unless an access panel is present. 🚨💡🔧
10/26/2025

A sharkbite fitting should not be utilized within a wall unless an access panel is present. 🚨💡🔧

In cases of doubt, additional silicone may be necessary.
10/26/2025

In cases of doubt, additional silicone may be necessary.

Newer roofer here, how to get tar out of skin (and clothes)?My gloves just gave out midway through tarring a valley. ...
10/26/2025

Newer roofer here, how to get tar out of skin (and clothes)?
My gloves just gave out midway through tarring a valley.

"Copper pipes + brass fitting = plumbing perfection 💧🔩 under the wooden beams 🛠️. Some green corrosion on the deal 🤷‍♂️....
10/26/2025

"Copper pipes + brass fitting = plumbing perfection 💧🔩 under the wooden beams 🛠️. Some green corrosion on the deal 🤷‍♂️."

I'm in the process of replacing a tub with a walk-in shower, incorporating a pre-made base and walls. The blue tape mark...
10/26/2025

I'm in the process of replacing a tub with a walk-in shower, incorporating a pre-made base and walls. The blue tape marks the location of the old tub and overflow drain, which I need to replace and re-route under the new shower base drain hole. The challenge I'm facing is the limited space available for installing a p-trap and ensuring proper slope. Does anyone have recommendations on how to properly plumb this? Thanks!

The use of a propress head is recommended for securing pipes in place during vertical soldering applications. This techn...
10/26/2025

The use of a propress head is recommended for securing pipes in place during vertical soldering applications. This technique is especially useful for prefabricated parts, enabling optimal positioning and streamlined soldering processes. Conversely, horizontal capping can be a difficult task, particularly when working with 2-inch or copper-to-brass connections. 💡🔩👍

This ceiling was primed with contract matt, causing the durable matt topcoat to fail over time. Even a lot of decorators...
10/26/2025

This ceiling was primed with contract matt, causing the durable matt topcoat to fail over time.

Even a lot of decorators use ‘cheap matt’ as the ‘mist coat’ on bare plaster. However, it’s the wrong thing to do, especially in a bathroom. We always advise you follow manufacturers’ and go with the primer they tell you to.

If I cut flush to the existing valve can I use this compression valve to replace or is the gap too wide.
10/25/2025

If I cut flush to the existing valve can I use this compression valve to replace or is the gap too wide.

How much for this toilet install Ricky? 😂 You should be paying me! 😂
10/25/2025

How much for this toilet install Ricky? 😂 You should be paying me! 😂

We had a plumber do all new plumbing in this bathroom. We've tiled and now we're ready to install the shower fixtures. I...
10/25/2025

We had a plumber do all new plumbing in this bathroom. We've tiled and now we're ready to install the shower fixtures. I think this plastic piece needs to be removed but not sure how. What am I missing here?

Address

30 Capitol Square SW, Atlanta, GA 30301
Atlanta, GA
30301

Website

Alerts

Be the first to know and let us send you an email when Calum Cuevas posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category