G-Force Fabrication

02/09/2025

23/08/2025

Introducing the GForce fabrication battery holder, designed to house up to a N70 size battery. Ideal for battery relocations in project/racecars, 4x4s, etc., with custom sizes and dual battery setups available upon request in stainless or mild steel. Feel free to reach out with any inquiries.

14/08/2025

Trenching bucket ready for work after receiving new floor, wear strips, cutting edge & adapters.

10/07/2025

Hydraulic rear door conversion carried out on our customers horse float.

03/07/2025

A couple of weeks back, we fabbed up an ice box tank for our Whipple-blown combo, soon to be set down between the rails of ole PURPUL.

Anyone who has been following would know we were almost ready to drop the hammer last year with the old setup after switching the car over to a Liberty 5spd among other upgrades. Despite the change in direction, we are looking forward to taking a dance on the dark side.

19/06/2025

The EFI conversion is progressing with the Haltech Rebel installed in a custom-made aluminium tray in the glovebox keeping it discreet but still at arms reach.

04/06/2025

We had Mitches Dragster in the shop last week to fit a CO2 activated parachute launcher in preparation for the Winternationals kicking off tomorrow in QLD , all the best mate 🤟🏽

22/05/2025

It was no easy feat mounting the steering rack and column with this bohemoth of a blower out front, but with a millimeter to spare here and there we managed to get the job done !

07/05/2025

30/04/2025

Ditch the blue painters tape when transporting or storing your pride and joy ! today we burnt out some Stainless steel Ls exhaust port block off plate’s as we wrap our new bullet up and head to the dyno.

If you’d like a set for yourself don’t hesitate to contact the page. Oh and how about them coil mounts ? 😮‍💨

07/04/2025

04/04/2025

We have recently completed a set of implement rims tailored to the customer's desired offset and pcd. All components were precision-cut, fabricated, and welded in-house.