Mechanical Engineering

Mechanical Engineering Welcome to our page

Is there a way to tighten up the swivel points?🤔💬🛠️
22/12/2025

Is there a way to tighten up the swivel points?🤔💬🛠️

I'm an idiot. I can't tell which cable is actually positive and which is negativeAny idea which is which? 🤔💬🚗🚙
22/12/2025

I'm an idiot. I can't tell which cable is actually positive and which is negative
Any idea which is which? 🤔💬🚗🚙

Is this slashed or cracked? I got my tires replaced 10 days ago and just noticed this on one of them. The tire shop is t...
22/12/2025

Is this slashed or cracked? I got my tires replaced 10 days ago and just noticed this on one of them. The tire shop is trying to say that it has been slashed or that I curbed it, which caused it to crack; however, the tire was curbed before the replacement and is actually the reason I had the tire replaced. Just looking for input and advice on how to move forward. Thanks 💡😊 🤔💬

HELP I cant get this back into placeI just replaced my cv axle on my 2013 ford explorer and now the lower control arm fr...
22/12/2025

HELP I cant get this back into place
I just replaced my cv axle on my 2013 ford explorer and now the lower control arm frontward bushing doesn’t want to go back into place no matter how hard I push on it it’s been sitting for over 4 days now and no luck what do I do?. This has happened before and I let it sit for 5 weeks but I don’t have time to let it sit now. 🤔💬🛠️

Alternator won’t go in in between the engine mounting points dunno what to do 🤔💬🛠️🚗
22/12/2025

Alternator won’t go in in between the engine mounting points dunno what to do 🤔💬🛠️🚗

Does this need to be replaced?... These belts are very expensive, and I drive (160) miles a day..... The dealership quot...
22/12/2025

Does this need to be replaced?... These belts are very expensive, and I drive (160) miles a day..... The dealership quoted me **$73.78** for labor, which is unacceptable in this economy... 🚗🤔💬🛠️

22/12/2025

That silent drive after you get your car fixed so it has to earn your trust back again 🚙🚗👍

Will this newly installed rear main seal leak?The seal is perfectly flat but has this one tiny spot where a punch appear...
22/12/2025

Will this newly installed rear main seal leak?
The seal is perfectly flat but has this one tiny spot where a punch appears to have pushed it in and deformed the face of the seal a tiny bit. Will it leak or is it good? 2010 Subaru Forester 2.5L 🤔💬

I need a new tire don’t I?Kiddo clipped a trailer somehow only damaging the tire. Holding air fine, but looking closer i...
22/12/2025

I need a new tire don’t I?
Kiddo clipped a trailer somehow only damaging the tire. Holding air fine, but looking closer in better light I can see a little bit of steel got nicked. 🤔💬🛞🚗

How would I go about removing four rusty bolts? I'm currently attempting to do a wheel bearing change, but I'm stuck on ...
22/12/2025

How would I go about removing four rusty bolts? I'm currently attempting to do a wheel bearing change, but I'm stuck on four bolts caked in rust. I've applied some rust penetrator and I've tried wrenching them, but I haven't been successful. Any tips? 🤔💡

A B C D Which one is first? 🤔💬
22/12/2025

A B C D Which one is first? 🤔💬

🤔💬🙆
22/12/2025

🤔💬🙆

Address

Jubail

Website

Alerts

Be the first to know and let us send you an email when Mechanical Engineering posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Mechanical Engineering:

Shortcuts

Share

Category