Pas’d Gas 64 Falcon

07/11/2025

07/04/2025

Happy Independence Day to all that are serving and that have served this great nation!! Be safe, have fun this 4th of July!!

06/25/2025

Come get your very own Pas’d Gas T-shirt!! https://www.bonfire.com/store/ol-skools-garage/?utm_source=copy_link&utm_medium=store_page_share&utm_campaign=ol-skools-garage&utm_content=default

05/13/2025

Picked up the upper clutch rod and firewall seal from Melvin's Classic Ford Parts!! Put the engine back in, put the gearbox/steering shaft in!! I need to find out how much travel the Z-bar needs, right now it’s hitting the pitman arm underneath!! Any info will be greatly appreciated!! Started taking the head apart!!

05/12/2025

Get your own Pas’d Gas T-shirt https://www.bonfire.com/pas8217d-gas/?utm_source=copy_link&utm_medium=campaign_page&utm_campaign=pas8217d-gas&utm_content=default

05/06/2025

So the 390 fits!! Set the engine in on the Speedway Motors engine support, got the Z-bar and brackets from Melvin's Classic Ford Parts mocked up!! Just need to get the linkage from the pedal to the Z-bar!! Feels great to get an engine in (even if it’s not welded in yet)!! Keeps the motivation going!!

05/05/2025

So, got the engine support cut to fit in between the frame rails, had to tap all the holes for the engine mounts and for the tilty thing (mock up block had mud dauber nests in about every bolt hole)!! Got that all done, and got the mounts onto the engine block!! Progress, feels good!!

04/29/2025

Got the down bar moved up and over out of the way of the master cylinder!! Cut the old 6 cylinder engine mounts out!! Next, gonna cut the new engine mount support down to fit between the frame rails and hopefully will be setting the engine in soon!!

04/28/2025

Good news; got the master cylinder mocked up!! Bad news; that one down bar is right up against it!! Solution, thankfully I only tack welded the bar in, so I can just cut the welds and move it!! Also, got the gearbox and steering column in!! Got the adapter for the steering in (just drilled and tapped it for some set screws for now), once the real column goes in, I’ll weld it in place!!

04/22/2025

So got the perches for the seat tracks welded in and then there were 2 seats!! The pictures might show the passengers seat is higher than the drivers, but it’s not!! The springs and padding are much better in the passengers seat than the drivers seat!! That’s ok though, they need to be recovered anyway!!

04/20/2025

Well, got all the seat track perches bent up, boxed in, and… ran outta welding gas!! I’ve got a small bottle than I can use to weld the perches in for now!!