05/12/2026
Looking for feedback on my 90s with kicks into a panel.
One piece of 3/4″ EMT and three pieces of 1″ EMT all needed the same kick distance from the rack to the panel. I assumed I could just make the same bend four times since the kick distance was identical, but the 1″ conduit ended up running into the 3/4″. I eventually moved my kick mark on the 1″ back by a half inch which helped.
Is it normal for the spacing to get really tight in the middle of the kicks? I was hoping the 3/4" spacing between conduits would stay consistent through the bend, but everything compresses in the middle and then opens back up.
Also, if anyone has tips, tricks, or little secrets for keeping spacing clean through these kicks or for matching 3/4″ and 1″ bends more consistently, I’d appreciate the advice.